Hot Tub Car

Start-Up

1. Polish the entire spa surface with Fast Gloss prior to filling.

2. Add Metal Gon during the fill cycle.

3. Balance water according got your Leisure Time dealer's instructions, or if you use Spa & Hot Tub Test Strips to test water, plug in the results using the online water analysis at LeisureTimeSpa.com for corrective action.

4. By adding pH Balance Plus* at this time, you will reduce the need to adjust your pH for up to three months.

5. Add any Leisure Time sanitizer.**

6. Test water using Spa & Hot Tub Test Strips to make sure water is still balanced.

7. Shock the Renew or OZ. Skip this step if using Reserve & Renew sanitizing system.

*pH Balance Plus is sold individually at your local spa retailer.

**See Spa Care Guide for Leisure Time's sanitizer choices.

Weekly

Always allow product to circulate in water for one minute this jets on prior tot adding another product. Circulate ware for 10 minutes after all products are added.

1. Test water using Spa & Hot Tub Test Strips from Leisure Time. Adjust as needed.

2. Add Bright & Clear according to label directions.

3. Add Defender according to label directions.

4. Add Enzyme according to label directions.

5. Add Renew or OZ to shock water according to label directions.

After Each Use

Shocking with Renew or OZ after each use is suggested. Shocking with Renew or OZ is required if using the Reserve & Renew System.

Monthly Cleaning

1. Remove the spa filter and clean using Instant Cartridge Clean.

2. Spa cover should be cleaned using either Cover Wipes or Cover Care & Conditioner.

3-Month Cleaning

1. Add Jet Clean according to label directions. (Remember to remove filter prior to use.)

2. Drain your spa

3. Clean the shell of the spa with CitraBright and wipe down.

4. Apply Fast Gloss to spa surface to protect, seal and keep the spa finish from fading.

5. Deep clean filter with Filter Clean.

6. Follow Start-Up procedure including having your source water tested professionally.

7. Replace your Spa Mineral Purifier

8. Clean you spa cover with Cover Wipes or Cover Care & Conditioner.

Prior to each use, test spa water to ensure that sanitizer level is in proper range of 3-5 ppm.

If spa is used more than three times per week, water testing and maintenance will need to be performed more frequently.

Filter cycle should be run a minimum of 6-8 hours per day.

To ensure water quality and keep the water easy to balance, Leisure Time recommends draining your spa water at least every three months, or more often if the spa is frequently used.

Proper Levels for Balanced Water

7.2-7.8

Alkalinity

80-120ppm

Calcium Hardness

150-400ppm

Sanitizer

3-5ppm

This program is intended for residential spa with average use. It is not designed for public, commercial, semi-public spas. If your spa is used more than 3X per week, you should check and make chemical additions more often than suggested.